PLEASE REFRESH THIS PAGE BEFORE ORDERING
AS THE AVAILABILITY CHANGES OFTEN

TKD Stereo Volume Control - TKD conductive Plastic 10K volume controls with aluminum knob.  Not the best anodize job on these knobs but the pots are new and unused.  These pots normally sell for $75+ each so here is a chance to grab a few for half price. We are selling the pair together with knobs for $75.00.

ONLY ONE SET AVAILABLE

Gainclone Monoblocks - Here is pair of Gainclone amplifiers using the National LM1875 power amp chip and our PS1 power supply.  Each amp includes a nice aluminum chassis, Noble conductive plastic volume control, a set of Cardas binding posts and a power cord.  There are no knobs for the volume controls, no rca jacks and the inputs have been disconnected so you'll have do a little bit of work to get them operational again.  We'll include a copy of the amplifier schematic.  $185.00 for the pair.

ONLY ONE PAIR AVAILABLE

Borbely Discrete Opamps - This is a set of Erno Borbely's discrete opamps.  Small in size, each of the opamps measures approximately 2"  x 2.5" I believe they are all configured as unity gain buffers but the gain can be adjusted.  They were pulled from an active crossover unit that saw very little use so they are practically brand new.  Great sounding buffers that you can most likely find a use for.  Click on the link for a copy of the schematic.  They require +/15V and a connection diagram will be included. Sold in pairs, $10 per pair.  6 pair available.

SCHEMATIC

TWO PAIR AVAILABLE

ULTRA PASSIVE - We have an overstock of Ultrapath chassis so we have decided to offer a few of these chassis packaged with our remote controlled stepped attenuators and configured as a 5 input passive linestage.  This offer will be limited to the quantities shown below. So order now if you are interested because they most likely will not last too long.

DETAILS:
Unfinished Bubinga Hardwood chassis with black anodized aluminum top, bottom and rear panels.  The chassis obviously have holes punched in the top for the Ultrapath tubes and output transformers so we are having some very thin Bubinga top plates made to cover these holes.... it should look pretty nice.  The chassis dimensions are 4"  x  12"  x  10".  The bubinga looks nice with several coats of high gloss tung oil finish, but you can also use laquers, polys or plain oil.

The kit includes one Option 4 remote controlled stepped attenuator kit, one set of blue LEDs for the input selection, power supply, hookup wire, 6 pair of RCA connectors and assembly instructions. Everything needed to build a complete remote controlled passive linestage.

Please don't ask for substitutions.

Assembled versions are available for an extra $250.00.  Select the UPASSY (assembly Fee) option below.  Assembly requires 2-3 weeks for delivery.  We finish the Bubinga on assembled units.

Ultra Passive Kit - $595.00 each

Ultra Passive Assembled - $845.00 each

Hammond Toroid Transformer - Model # 182Q9 .  New in the box and includes mounting hardware.  120/240Vac primary.  Two secondaries.  18Volts @6.7A or 9Volts @13.4A. $30.00 each.

Two Available

Hammond Toroid Transformer - Model # 182M18 .  New in the box and includes mounting hardware.  120/240Vac primary.  Two secondaries.  36Volts @3.3A or 18Volts @6.7A. $30.00 each.

Two Available

Steel/Aluminum Chassis - This is a steel chassis with aluminum top and bottom. It's a very nice size for an ST70 replacement or similar sized amp project. Steel sides, heavy gauge aluminum top, ventilated aluminum bottom, very sturdy with black powder coat finish.  Measures 17"W  x  12"D  x  2"H.  Includes an IEC power connector and hardware.  $50.00 for the chassis.

ONLY ONE IN STOCK

Aluminum Chassis - PFT aluminum chassis with powder coat finish.  We will include a heavy duty internal mounting plate (not shown) with your order.  This plate is an optional install inside of the chassis and is used for mounting heavy items like power transformers, chokes, etc.  Measures 9"W x 7"H x 12"D.  Top cover included. $50.00 for the chassis.

ONLY ONE IN STOCK

Aluminum Chassis - PFT aluminum chassis with powder coat finish.  Measures 17"W x 2.5"H x 12"D.  This is a new chassis but has a few holes punched in the bottom panel.  It was slated for a prototype project but was never used. $45.00 for the chassis.

ONLY ONE IN STOCK

Aluminum Chassis - PFT aluminum chassis with powder coat finish.  Measures 12"W x  3.5"H x 9"D.  This is a used chassis with rack mount ears.  There are no holes drilled in the front panel.  Ventilated top cover and includes the two XLR connectors shown on the back. $20.00 for the chassis.

ONLY ONE IN STOCK

Zephyr B Stock - We have 2 Zephyr B stock kits available.  The Zephyr is our remote controlled passive linestage and both of these units have the black front panels.  Minor blemishes.  Save $85.00

Checkout the Zephyr page for all details.

Two available for $350.00 each.

ONLY ONE LEFT IN STOCK

SOLEN - Solen Fast Caps.  Metallized polypropylene

Available quantity in red

Rocker Switch - Heavy duty rocker switch.  20A @ 125V or 15A @ 250Vac. Great for wiring solid state amps and ac power filters.

A set of 11 switches. $20.00 for all 11 switches.

Caddock 2W Metal Foil Resistors - You probably can't make a better resistor than this.  Non-inductive bulk foil design with gold-plated OFC copper leads.  These are 2W versions but are just slightly larger than a typical 1/2W resistor.  They are normally priced around $10 each.  Grab'em for 2 bucks a piece.  Quantity available in red.

Electra-Print Parafeed - Here is something unique.  A set of Parafeed Chokes and Output Transformers custom wound for us by Electra-Print Audio.  Not so unique you say. Well,  these output transformers have a single 2 ohm tap.  That's right, these transformers were wound to be used with a line array of speakers.  Parallel four 8 ohm speakers for increased efficiency and then build yourself a 2A3 or 300B parafeed amp to drive them.  Primary impedance of the output transformers is 3K.  The chokes are rated at 50H.  New and unused.

Originally $400.00.   Now just $200.00 for the complete set.  Only 1 set available.  I'll even include a coupon for 20% off your next order to help with your amplifier costs.

Neutrik XLR Connectors - 6 gold plated 3-pin female XLR connectors.  These connectors are approximately 10 years old but never used.  $20 for all 6 pieces.

Vampire RCA Connectors - 6 (3 pair) gold plated Vampire M1F RCA connectors.  These connectors are approximately 10 years old but never used.  $18 for all 6 pieces.